Selecting The Reply Code - Garrecht Avionik VT-01 Bedienungsanleitung

Garrecht Avionik GmbH

3.4. Selecting the reply code

Use the double shaft rotary encoder to select or modify the standby reply code of
your transponder.
inner
knob
knob of the rotary encoder to activate the modified code.
It will replace the code shown in the position of the active reply code.
FL045
R
Sample:
Mode-A reply code needs to be changed. Use the outer knob of the double shaft
encoder to select the position of the code to be modified. A blinking cursor is
indicating the selected position. Use the inner knob to modify the value at the
selected position. When all changes are done, press the inner button to activate the
modified standby code.
Revision: 1.2
VT-01 Transponder
Select the position to be modified by rotating
the outer knob. The selected position will be
indicated by a blinking cursor
Use the inner knob to set the required value.
outer
If all positions of the standby reply codes
knob
contain the required values, press the inner
>0021
ALT 0022
11
Active reply code
Standby-
reply code
User manual
Dokument 01.0200.10E
12.01.2006