Installation Preparation; Before You Begin - Avaya 3500 Series Handbuch

Warning:
Disconnecting the power cord is the only way to turn off power to this device. Always connect
the power cord in a location that can be reached quickly and safely in case of an
emergency.
Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.

Installation preparation

Before you begin

Ensure the area where you install and use the switch meets environmental requirements.
You can install a single ERS 3510GT or ERS 3510GT-PWR+ switch on any flat surface that
can safely support the weight of the switch and attached cables. An ERS 3510GT switch
weighs 3.85 lb (1.75 kg). An ERS 3510GT-PWR+ switch weighs 5.9 lb (2.70 kg). Cable weight
varies for each installation.
You can install two ERS 3510GT or ERS 3510GT-PWR+ units together to form one standard
width rack-wide system using a 19 inch side-by-side Rack Mount Kit (ordered separately).
You can install the ERS 3524GT, ERS 3524GT-PWR+, ERS 3526T, or ERS 3526T-PWR+
switches in an equipment rack using the brackets provided.
Environmental requirements
The following list describes the requirements for the switch environment.
• ambient temperature between 32°F and 122°F (0°C and 50°C)
• relative humidity between 0% and 95% noncondensing
• no nearby heat sources such as hot air vents or direct sunlight
• no nearby sources of severe electromagnetic noise
• no excessive dust
• adequate power source within six feet; one circuit required for each power supply
Regulatory Information 5.0
Installation preparation
February 2012 23