GYS GYSPRESS 8T PUSH PULL Bedienungsanleitung Seite 15

GYSPRESS 8T PUSH PULL EN
RESULT OF THE INSTALLATION OF SELF-PIERCING RIVET
STAMP AND CALIBRATE HOLES FOR FLOW-FORM RIVETS
To punch the sheet to a specific diameter, it is necessary to use a specific die. This die protects the sheet from damage.
If using Flow-Form rivets, it is necessary to drill metal sheets before in order to put the rivet in place. The punch and
the die above allow for a more precise punching as well as allowing the fitting of Flow-Form rivet.
15