Disposal Of The Old Device - Caso Slow Juicer SJW 500 Original Bedienungsanleitung

The device stops during
operation.
There is too much pulp in
the juice.
The feeding tube will not
close.
Dying of the plastic parts.
► If above mentioned steps don't solve the problem, please contact your customer
service.
► Please clean the device before sending it to customer service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste under
any circumstances.
► Utilise the collection point, established in your town, to return and recycle old electric
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
► Ensure that your old device is stored safely away from children until it is taken away.
 If juicing ingredients with small seeds, after a few servings,
it may reduce the juice yield.For best result, disassemble
and wash the top-set (without motor block) in between
juicing.
 If there is seed residue on the bottom of the strainer, this
can affect juicer performance and the overall juice yield.
 Check whether too much food is used.
 Check whether the food contains hard cores.
 Use REV-function and follow the instructions in "If the
device stops during operation"
 When continuously juicing, and depending on the
ingredient, the juice may contain a lot of fine pulp.
 To reduce the fine pulp, clean the top-set (without motor
block) frequently and extract the pulp.
 Use a mesh strainer and put the juice through it to collect
the unwanted pulp.
 If too many ingredients are inserted at the same time, it
may cause the juicer to stop frequently. This can lead to
pulpy juice. Insert the ingredients slowly and few at a time.
 Make sure the pressure auger is latched in order for the
feeding tube to close properly.
 After juicing, if the juicer is not cleaned right away, the
remaining pulp inside the top-set can dry up which can
make disassembling and cleaning hard. This can also
affect the juicer's performance and color.
 Ingredients which are rich in colorants, for example carrots
or spinach, may dye the plastic parts. The dying does not
affect the device.
Please note
Please note
43