Cleaning; Troubleshooting; Security Advices - Caso Slow Juicer SJW 500 Original Bedienungsanleitung

16.2 Cleaning

► You can use the provided cleaning brush.
► Motor unit and cable should not come into contact with water. Wipe the motor unit and
the cable only with a damp soft cloth.
► Immediately clean the device after each use. If remaining residue in the device dries up,
it can make disassembling and cleaning difficult. The residues may affect performance
in future uses.
1. Empty the residue container. Remove the silicone plug (12) from the residue outlet at
the bottom of the middle part.
2. You can clean all components except the motor unit (8) in the dishwasher.
Alternatively: Rinse all parts, except motor unit, thoroughly under running water and
clean with water and a mild cleaning detergent.
3. Use the cleaning brush, to clean the juice strainer and sorbet strainer thoroughly.
4. Clean the pressure auger with running water and especially clean the bottom side of the
pressure auger.
5. Then thoroughly clean the residue outlet, the juice outlet and lock with the cleaning
brush and remove all residues.
6. After cleaning, use a dry cloth to dry all parts thoroughly. Assemble the device
completely and store it at a dry, safe place.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Security advices

► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
17.2 Troubleshooting
Problem
The device does not start.
The amount of juice is very
little and residues are still
damp.
Please note
Attention
Solution
 Please check whether the plug is properly plugged in.
 Please check whether the device is assembled correctly
and lid is closed.
 Check whether stale food is used.
 Food that was stored in the refrigerator for a long time
must be soaked in clear water for at least 10 minutes
before using them.
 Different ingredients hold different amounts of fluid that will
yield different amounts of juice.
 Check if all parts were assembled correctly.
42