Datamax I-Class Kurzanleitung Seite 37

Media Loading
Centerplate
Roll Media
Media Hub
Printhead Latch
Media Sensor
Rolled Media
1. Open the cover. Unlatch and raise the printhead. Slide a roll of media onto the
media hub. Push the media all the way back until it stops, (it will be resting
against the printer's centerplate).
2. Route the media under the media idler, up through the printhead area, (ensure
that the media passes through the media sensor), and over the platen roller.
Continue to pull until approximately 4-inches of media are visible from the front
of the printer.
3. Slide the media guide against the edge of the media.
4. Lower and latch the printhead.
5. Press the feed button several times to ensure proper tracking.
6. Close the cover.
Media Guide
Media Idler
Internal Rewind Hub
Bottom Fan-Fold Media Slot
Rear Fan-Fold Media Slot
25