Datamax I-Class Kurzanleitung Seite 23

Ribbon Loading
Ribbon Take-up Hub
Ribbon
Ribbon Supply Hub
Lower Ribbon Roller
1. Open the cover. Unlatch and raise the printhead.
2. Slide a roll of ribbon onto the ribbon supply hub. Push the ribbon all the
way back until it stops.
3. Route the ribbon from the ribbon supply hub under the lower ribbon roller,
and over the platen roller. Pull the ribbon up and over the ribbon take-up
hub.
4. Rotate the ribbon take-up hub several turns counterclockwise to remove any
slack in the ribbon.
5. Lower and latch the printhead.
6. Close the cover.
13