Lowering The Vehicle; Attaching The Adapter (Optional) - Ultimate Speed Hg01040 Bedienungs- Und Sicherheitshinweise

Place the hydraulic vehicle jack under one
of the lifting positions as shown in the owner's
manual supplied by the vehicle manufacturer.
Ensure that the support plate
loaded. By moving the lifting handle
and down, raise the vehicle sufficiently to allow
you to insert axle stands under the vehicle
(see Fig. C).
Allow the vehicle to come down on to the
axle stands by slowly opening the release
valve by turning the lifting handle
5
anticlockwise.
The jack is NOT FOR HOLDING the
vehicle.

Lowering the vehicle

DANGER TO LIFE! Check that no person
or object is under the vehicle before you
lower it.
First raise the vehicle slightly (as described
earlier) in order to be able to remove the
axle stands.
Turn the release valve
the vehicle lowers, but do not turn it to the
extent that it detaches or hydraulic oil leaks
from the release valve
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
Pull the trolley jack out from under the vehicle
and fully lower the lifting arm
Close the release valve
clockwise.
Attaching the adapter
(optional)
From its original height (13.5 cm), bring the
vehicle jack to a height of 34 cm by moving
the lifting handle
section on "Using the jack").
Remove the hex bolt
with a socket wrench plus socket (18 mm)
and a ring spanner (19 mm) (see Fig. E).
12 GB/IE
is centrally
3
1
1
anticlockwise until
5
(see Fig. D).
5
.
2
by turning it
5
up and down (see the
1
from the nut
10 11
Take out the saddle
adapter
9
above, guide the hex bolt
adapter
9
up Place the nut
(see Fig. F).
Fix the hex bolt
together with a socket wrench plus socket
(18 mm) and a ring spanner (19 mm) (see
Fig. G).
Lower the vehicle jack back down to its orig-
inal height by turning the release valve
anticlockwise. Ensure that the release valve
does not become detached and allows the
hydraulic oil to escape (see the section on
"Lowering the vehicle").
If you no longer need to use the adapter
remove it by releasing the hex bolt
the nut
11
(18 mm) and a ring spanner (19 mm) (see
Fig. E).
Then fix the hex bolt
place together inside the load plate
safe keeping.
Cleaning and care
Never use harsh or corrosive cleaning agents.
Liberally grease all external moving parts.
Clean the hydraulic trolley jack using a
slightly oily cloth.
Fully lower the lifting arm
handle sleeve
trolley jack in the smallest possible space.
Maintenance and service
Note: Refilling or topping up with hydraulic
oil may only be carried out by specialist
personnel! Always use hydraulic oil that fulfils
the specification for SAE 10. Please note
that filling with too much oil may adversely
affect the functioning of the vehicle jack. Fill
with a maximum of 115 ml oil when all the
oil has been used. Fill the hydraulic oil
first and place the
13
on to the load plate
3
through the
10
and load plate (see Fig. F).
3
under the load plate
11
and nut in place
10 11
with a socket wrench plus socket
and the nut
10
and lifting
2
to be able to store the
6
. From
3
5
5
,
9
from
10
in
11
for
3