Setting Of Additional Remote Controls; Remote Control Memory Clearing; Full Memory Clearing - cherubini TDS GOLD Einstellanleitungen

SETTING OF ADDITIONAL REMOTE CONTROLS

Up to 15 single channel remote controls can be set, including the light/wind sensor.
The setting and deleting of the global channel in the multichannel remote controls is
automatic. The global channel cannot be used as a standard channel.
T1: Already programmed remote control
Tn: Additional remote control
A
+ B
T1

REMOTE CONTROL MEMORY CLEARING

It is possible to delete singly all the memorised remote controls. When the last one
is deleted the control unit initial condition is restored. The same applies to the single
channels of a multichannel remote control: just select the channel to cancel.
Tn: Remote control to be cleared
A
+ B
Tn
The full memory clearing can be performed in two ways:
1) WITH THE REMOTE CONTROL
Tn: Already programmed remote control
A
+ B
Tn
GB
B
T1
A
Tn

FULL MEMORY CLEARING

B
Tn
24
B
Tn (2 sec)
B
Tn (2 sec)
A
+ B
Tn (4 sec)