Troubleshooting; Maintenance; Technical Specifications - FOLLO FUTURA STABILIS Bedienungsanleitung

Counter:  The counter (5) is a bicycle computer. It
4.
registers when training starts, and is switched on
automatically (displaying the last used function). Use
the button (6) on the bicylcle computer to switch
between the different functions: Distance, time,
speed, clock and auto (changes regularly between
all functions). Holding down button (6) will clear time
and distance (not the clock). The computer will
switch off automatically when not in use for a period.
Read more about the bicycle computer's functions in
the separate instructions for use.

MAINTENANCE:

Inspect the machine regularly for damage, play or missing parts. In the case of damage or
other deficiencies, the machine must not be used until it has been repaired.
5. Floor plates: Adjustable inwards
and outwards by loosening knob
(9). Adjust to required position and
tighten knob (9).

TROUBLESHOOTING:

•
Counter / computer:
If the counter stops working (empty display), check the battery first. If the counter is
working, but does not count, check that the black transmitter on the largest nickel plated
disc (No. 29 on the parts drawing) is in position. Check also that the opening between the
black transmitter and the sensor (immediately below the computer) is correct when they
pass each other. The opening must be between 2 and 4 millimetres (maximum 5 milli-
metres). Adjust the opening by carefully bending the baseplate to which the sensor is
attached. See also the folder that accompanied the computer.
•
Brake resistance:
If no brake resistance is felt or the resistance is not functioning properly, the handle may
have been adjusted too far in the wrong direction (several turns). Turn the handle
clockwise until heavy resistance is felt. Then adjust to the required resistance. If
resistance is uneven, inspect the brake lining (No. 30 on the parts drawing). If the brake
lining has loosened, it must be replaced.
If these guidelines fail to rectify the situation or if there are other faults or deficiencies, contact
your dealer for replacement parts or for service.
NB! The manufacturer responsibility for CE marking is invalidated if any form of
modification is carried out.
EXTRA EQUIPMENT:
- Large pedals
- Handles
- Hooks for wall bars

TECHNICAL SPECIFICATIONS:

Height 40 cm
Width: 77 cm
Length (with/without floor plates): 111 / 54 cm
Weight (with/without floor plates): 15,2 / 8,5 kg
RECYCLING:
This machine is comprised mainly of steel and plastic. When separating for recycling, the
handles and plastic details must be handled as hazardous waste. The remaining parts of the
machine can be handled as metal.
The "CE" mark indicates that this product conforms with European standards
for health, safety and the environment.
08/08/18
Side 8
Rev: 16