Guidelines For Use; Safety Information - FOLLO FUTURA STABILIS Bedienungsanleitung

Thank you for choosing a Follo Stabilis product. We have prepared this instruction manual
to enable you to get the best results from the product. Please read these instructions
carefully before assembling and using the trainer.
Contents:
- Purpose
- Unpacking
- Maintenance
- Extra equipment
- Recycling
THE PURPOSE OF THE TRAINING:
The leg training machine is designed to improve circulation. It can be used standing on the
floor (as shown in the illustration on the cover) while the patient sits on a chair/wheelchair,
which has been placed on the floor plates (to keep the machine steady and in position
during use). Select a resistance that the patient can keep up for at least 15 minutes. Start
pedalling using even movements, extending movements as far as possible. Read off time
and distance on the counter.

SAFETY INFORMATION:

•
Make sure that nothing can be pinched or jammed and that the pedals rotate easily and
are properly secured.
•
Always test the machine's functions yourself and allow the patient to test all functions
under supervision before handing out the
product for self-training.
UNPACKING/ASSEMBLY:
•
Take care when removing the machine from
its packaging. Do NOT use a knife or other sharp instrument as this may damage the
machine. Inspect the machine for any transport damage.
•
Place the machine on the floor and mount the floor plates as shown in the left drawing.
Remove screw (A). Stand on the frame (B) and lift up the main beam (C) until the
angled supporting rod (D) lines up with its attachment point. Replace screw (A). Place
two washers between the supporting rod and the attachment point. Do not use a
washer on the outside of the supporting rod (see drawing).
- Safety information

- Guidelines for use

- Troubleshooting
- Technical specifications
- Spareparts list
GUIDELINES FOR USE:
Use:  The leg trainer machine is designed for use standing on the floor while the patient
1.
sits on a chair/wheelchair, which has been placed on the floor plates. Make sure the
machine is properly attached to the floor plates and that the chair/wheelchair is steady.
Adjusting resistance:  Adjust resistance using
2.
the levers (1). Rotating the levers in a clockwise
direction increases reistance, and loosening anti-
clockwise reduces resistance.
Adjusting the pedals:  The crank throw
3.
of the pedals may be adjusted by first
loosening the knob (2). Pull out the lockpin
(3) and push or pull the pedal to the
required position. Make sure that the
lockpin (3) lines up with a hole and replace
the lockpin. Tighten the knob (2).
08/08/18
Side 7
Rev: 16