Disposal; Manufacturer's Warranty - Tools - Hilti GX 120-ME Bedienungsanleitung

Fault
Fastener cannot be removed
from nosepiece.
Pipe rings and other fasteners
cannot be inserted in the tool
nosepiece.

10 Disposal

Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information. If you wish to bring the tool to a materials separation facility yourself: Regional and international directives
and regulations must be observed.

11 Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
Possible cause
A fastener is jammed in the tool
nosepiece.
Fragments of the magazine strip are
lodged in the tool nosepiece.
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
NOTE
Observe the gas can expiry date printed on the edge of
the can.
Remedy
Remove the tool nosepiece from the
tool. Fit the tool nosepiece into the
support supplied and use the pin
punch to remove the fastener.
CAUTION
Do not damage the tool nosepiece.
See section: 7.4.1 Removing the
nosepiece 9
See section: 7.7 Removing a jammed
fastener 15
Remove the fragments of the
magazine strip from the tool
nosepiece.
en
25