Power Saving Mode - Toshiba RAV-RM561BTP-E Anleitung

External static pressure
When using the wireless remote controller
To set up the external static pressure, use the DIP switch on the circuit board of the wireless reception part.
For details, refer to the instruction manual of the wireless remote controller kit. Alternatively, use the switch on the
indoor micro computer circuit board as shown in the following figure and table.
* Once switched, the settings "0001", "0003", and "0006" can be changed, but to reset to "0000", you need to set
the switch to the normal (default) position and use a separately-sold wired remote controller to overwrite the data
with "0000".
SW501
125-EN
SW501-1 OFF ON OFF ON
SW501-2 OFF OFF ON ON
SET DATA 0000 0001 0003 0006
To reset to the factory default
Switch off SW501-1 and SW501-2, connect a separately-sold
wired remote controller, and then perform the procedure for
installing a separately-sold filter on this page to set the [5d] data
to "0000".
– 63 –
Filter sign setting
According to the installation condition, the filter sign
term (Notification of filter cleaning) can be changed.
Follow to the basic operation procedure
1 2 3 4 5 6
( → → → → → ).
3
• For the CODE No. in Procedure , specify [01].
4
• For the [SET DATA] in Procedure , select the SET
DATA of filter sign term from the following table.
SET DATA Filter sign term
0000 None
0001 150 H
2500 H
0002
(Factory default)
0003 5000 H
0004 10000 H
To secure better effect of
heating
When it is difficult to obtain satisfactory heating due to
installation place of the indoor unit or structure of the
room, the detection temperature of heating can be
raised. Also use a circulator or other device to circulate
heat air near the ceiling.
Follow to the basic operation procedure
1 2 3 4 5 6
→ → → → →
( ).
3
• For the CODE No. in Procedure , specify [06].
4
• For the SET DATA in Procedure , select the SET
DATA of shift value of detection temperature to be
set up from the following table.
SET DATA Detection temperature shift value
0000 No shift
0001 +1 °C
+2 °C
0002
(Factory default)
0003 +3 °C
0004 +4 °C
0005 +5 °C
0006 +6 °C

Power saving mode

Performing settings of the power saving
mode
* When RAV-SP***2AT / RAV-SM***3AT or older is
used, the displayed setting changes, but the actual
power level is always "75%".
1
5 4 3 2
1
Push button for at least 4 seconds or
more when the air conditioner is not
working.
, symbol flashs.
2
Push (left side of the button) to select
an indoor unit to be set.
• Each time the button is pushed, UNIT No.
change as follows:
UNIT No. UNIT No. UNIT No.
1-1 1-2 1-3
UNIT No.
1-4
The fan of the selected unit runs.
3
Push TIME buttons, to adjust the
setting of power level.
• Each push of the button changes the power
level by 1% within the range from 100% to 50%.
• The factory default is 75%
Setting of power level in
power saving mode
4
Push button.
5
Push button to complete the setting.
126-EN