Inhaltsverzeichnis
Werbung
MILK FROTHER
INSTRUCTION MANUAL
Read this booklet thoroughly before using and
save it for future reference
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions before using.
2. Before connecting the appliance to the
power supply, check that the voltage
indicated on the appliance corresponds with
the voltage in your home. if this is not the
case, contact your dealer and do not use the
kettle.
3. the attached base can not be used for other
than intended use.
4. do not operate the appliance without
anything in it to avoid damaging the heat
elements.
5. unplug from the outlet when not in use and
before cleaning. allow to cool before putting
on or taking off parts, and before cleaning
the appliance.
6. do not let the cord hang over the edge of a
table or counter or touch a hot surface.
7. do not place on or near a hot gas or electric
burner or in a heated oven.
8. Ensure that the appliance is used on a firm
and flat surface out of reach of children, this
will prevent the appliance from overturning
and prevent damage or injury.
9. Keep hands and utensils out of container
while blending to reduce the risk of severe
injury to persons or damage to the blender.
10. To protect against a fire, electric shock or
personal injury, do not immerse cord, electric
plugs, jar or base in water or other liquids.
11. close supervision is necessary when any
appliance is used by or near children.
12. do not touch the hot surface. use the handle
or the button.
13. Extreme caution must be used when moving
an appliance containing hot water.
14. avoid contacting moving parts.
15. the use of attachments not recommended
or sold by manufacturer may cause fire,
electric shock or injury.
16. do not operate any appliance with a
damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in
any manner. Return appliance to the nearest
authorized service facility for examination,
repair or electrical or mechanical adjustment.
17. the appliance only used for frothing and
heating milk. do not use the appliance for
other than intended use.
2
18. this appliance has been incorporated with a
grounded plug. please ensure the wall outlet
in your house is well earthed.
19. This appliance is not intended for used by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliances
by a person responsible for their safety.
20. always operate the appliance with cover in
place.
21. never place this appliance on or near a hot
gas or an electric burner or where it could
touch a heated appliance.
22. this appliance is intended to be used in
household and similar applications such as:
– Staff kitchen areas in shops, offices and
other working environments;
– Farm houses;
– By clients in hotels, motels and other
residential type environments;
– Bed and breakfast type environments.
23. children should be supervised to ensure that
they do not play with the appliance.
24. do not use outdoors.
25. save these instructions.
KNOW YOUR MILK FROTHER
1. lid
2. Jar
3. switch button (with indicator)
4. power base
5. handle
6. Mixing paddle
7. Frothing paddle
BEFORE THE FIRST USE
The appliance can be used for finishing the
following tasks separately: I. frothing and
heating milk; II. only frothing separately,
without heating; III. only heating separately,
without frothing.
1. Before using your milk frother, clean all the
parts according to the section "clEaning
and MaintEnancE".
2. important: do not wash any parts in the
dishwasher, and do not immerse the jar in
water. this may permanently damage the
product and void the warranty.
3. the appliance is equipped with two
accessories of mixing paddle and frothing
paddle, the mixing paddle is used for mixing
milk during heating to prevent from sticking.
the frothing paddle is used for frothing
milk during heating or is used for frothing
separately, but no heating. select desired
accessory according to your task.
NOTE: the max capacity of the jar is 450ml.
OPERATION OF YOUR MILK FROTHER
I. FROThING ANd hEATING
1. Place the appliance on a flat surface.
2. select frothing paddle, then open the lid and
insert the frothing paddle onto the shaft on
the bottom of jar.
3. Fill the jar with the desired amount of milk,
and replace the lid.
NOTE: the max milk quantity permitted to add is
100ml, to avoid milk overflowing after frothing.
4. place the jar on the power base and connect
the plug into a power outlet, the indicator will
light red.
5. press the switch button once, the indicator
will light blue. then the appliance will start
to work. Once the temperature of milk
has achieved about 68±10℃, the heating
element will stop heating and the frothing
paddle will stop rotating automatically;
the indicator will illuminate red again until
unplugging the power outlet.
NOTE: during operation, you can stop
operating by pressing the switch button once.
6. When the appliance has stopped operating,
open the lid, pour out the warmed and
frothed milk to enjoy it.
CAUTION: Minimum 3 minutes rest time
must be maintained between two continuous
cycles, otherwise, the appliance will enter
self-protection state automatically after working
for 5 cycles continuously, the indicator will be
illuminated blue and flash, the switch button
will not be activated, after about 5 minutes, the
appliance will enter standby state and you can
continue operating the appliance.
7. always turn off the milk frother and
disconnect the power supply when not use.
3
II. ONLy FROThING SEPARATELy, wIThOUT
hEATING
1. according to the 1-4 steps in the section of
"Frothing and heating".
2. press the switch button for three times
continuously within 2s, the indicator will
illuminate blue and blink, the frothing paddle
will rotate for frothing milk separately, but
the heating element will not heat. and the
appliance will automatically stop rotating
after operating. the indicator will illuminate
red again until unplugging the power outlet.
NOTE: during operation, you can stop
operating by pressing the switch button once.
3. When the appliance has stopped operating,
open the lid, pour out the frothed milk and
enjoy it.
CAUTION: Minimum 3 minutes rest time
must be maintained between two continuous
cycles, otherwise, the appliance will enter self-
protection state automatically after working for
5 cycles continuously, the working indicator will
flash and the switch button will not be activated,
after about 5 minutes, the appliance will enter
standby state and you can continue operating
the appliance.
4. always turn off the milk frother and
disconnect the power supply when not use.
III. ONLy hEATING SEPARATELy, wIThOUT
FROThING.
1. Place the appliance on a flat surface.
2. select mixing paddle according to your task.
then open the lid, insert the mixing paddle
onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk,
and replace the lid.
NOTE: the max milk quantity permitted to add
is 200ml, to avoid milk overflowing after mixing
or frothing.
4. place the jar on the power base and connect
the plug into a power outlet. the indicator
will illuminate red.
5. press the switch button twice continuously
within 2s, the indicator will light blue. then
the appliance will start to work. Once the
temperature of milk has achieved about
68±10℃, the heating element will stop
heating and the mixing paddle will stop
rotating automatically; the indicator will
illuminate red again until unplugging the
power outlet.
NOTE: the rotation of mixing paddle is only
used for avoiding sticking. it will not froth the
milk.
Werbung
Inhaltsverzeichnis
