Bosch BLE 200 Professional Bedienungsanleitung Seite 22

OBJ_BUCH-71-002.book Page 22 Friday, July 20, 2007 10:07 AM
22 | English
Operating Instructions
Marking
The height of the laser beam can be marked at the centre mark 7
on the right and left of the measuring tool when it runs through the
centre of the reception area 6. The centre mark is 50 mm away
from the upper edge of the measuring tool.
Aligning with the Spirit Level
The measuring tool can be aligned vertically (plumb line) with the
spirit level 1. A measuring tool applied out-of-level leads to faulty
measurements.
Attaching with the Holder (see figure A)
With the holder 14, the measuring tool can be fastened to a con-
struction laser measuring rod 16 (accessory) as well as to other
auxiliary tools with a width of approx. 5 to 50 mm.
Slide the holder 14 sidewards into the retainer openings 8 on the
rear side of the measuring tool until it can be heard to latch.
Loosen the locking screw 17, slide the holder onto the construc-
tion laser measuring rod 16, for example, and retighten the locking
screw 17.
The upper edge 15 of the holder is located at the same height as
the centre mark 7 and can be used for marking of the laser beam.
To remove the measuring tool from the holder 14, press the holder
latch 13 and pull the measuring tool out of the holder.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the
measuring tool can be attached to steel parts via the face and rear
side using the magnet plate 12.
1 609 929 L81 | (20.7.07) Bosch Power Tools