Herunterladen Inhalt Inhalt Diese Seite drucken

Iphone + Ipad - AUDAC MTX48 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für MTX48:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

iPhone + iPad

The application which is available from the app store turns your
iPhone or iPad into a fully fledged audio matrix controller when using
it in combination with the MTX. Simply connect it to your LAN network
by using a wireless access point, and after installing the app on your
mobile device, it is ready to be used.
To install the app on your mobile device, just tap the app store button
and download the 'MTX Remote' app by AUDAC on your mobile
device, or download the application from iTunes®. (Note: when the
app is downloaded through iTunes®, you need to synchronize your
iOS device first.)
After the app is installed, make sure your mobile device is connected
to your wireless network and run the app by tapping the 'MTX Remote'
app button. When starting-up, it will ask for the IP address of the
device where it should be connected to. Enter your MTX password.
The mobile applications only offers you the possibility to change
basic configuration settings like volume and routing control, so the
'Administrator' and 'User' password both offer you the same rights
here.
After the password is entered, you will be redirected to the main
screen of the app, showing one fader for one specific zone. The
volume for this specific zone can be set by moving the fader up and
downwards and the input signal can be selected by tapping on the
input signals name. Then a list will be shown whereout the desired
input signal can be selected. The green button on the bottom can be
used to mute the volume for the corresponding zone, and will turn
red when the volume is muted. To switch between several output
zones, just sweep over your display from left to right, or right to left.
The iPad app is working similar and very intuitive just as the iPod
and iPhone app, the only difference is that multiple faders will be
shown besides or above each other. In horizontal position, all faders
will be shown next to each other, while in vertical position two rows
of faders will be shown above each other
.
35

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für AUDAC MTX48

Diese Anleitung auch für:

Mtx88

Inhaltsverzeichnis