AUDAC MTX48 Bedienungsanleitung Seite 26

Wall panel inputs
The other two inputs (Inputs 7 and 8) are wall panel inputs. These input signals are
coming from external Wall Panel input devices, which are patched to the Wall Panel (WP)
RJ45 connectors on the MTX. These zone inputs are separately for every zone, and not
linkeable with other zones. Input 7 is the "MWX65/WLI" input, containing the signal
coming from external All-in-one (MWX65) or Line (WLI) input units. Input 8 is the "WMI"
input, containing the signal coming from external Microphone (WMI) input units.
Two-band tone control
On the right side of the window there are two faders displayed whereby the sound settings
can be adjusted through two-band tone control. The leftmost fader indicated with "Bass"
offers the possibility to adjust the level of the low frequencies, while the rightmost fader
indicated with "Treble" offers the possibility to adjust the level of the high frequencies.
The sound level level for both low and high tones can be amplified or attenuated between
+14 dB and -14 dB. This can be easily done by sliding the faders up and down.
Assign input names
For a better overview of all the inputs, a name can be assigned to every specific input.
The name of the input can be changed by double clicking on the input name shown in
the "Zone Settings" screen. When a cursor comes up, remove the existing name with the
backspace key, and just change the name into the desired name. After the desired input
names are entered, they will be stored automatically when pushing the "Back" button and
will be recalled when reloading the MTX interface.
Input selection
In the "Input Selection" menu can be selected which inputs should be made available in
the "Quick Selection Menu" for this zone.
Back
Click the "Back" button to go back to the main window.
MTX Zone settings screen
26