AUDAC MTX48 Bedienungsanleitung Seite 16

Configuration functions
Priority 1
Enable /
Volume
(per zone)
Priority 2
Enable /
Volume
(per zone)
Paging Volume
(per zone)
Mono / Stereo
output
(per zone)
Set Wall Panel
Address
16
Priority message from Microphone Input 1 will be announced to
priority enabled zones.
- Set LED for corresponding zone to 'Volume'
- Hold rotary button for corresponding channel down for 3 seconds
(Volume LED starts blinking rapidly)
- Priority can be enabled and volume can be set by rotating the
button (Priority is disabled when volume is set to zero)
- Press rotary button once again to return back to main menu
Priority message from Microphone Input 2 will be announced to
priority enabled zones.
- Set LED for corresponding zone to 'Routing'
- Hold rotary button for corresponding channel down for 3 seconds
(Routing LED starts blinking rapidly)
- Priority can be enabled and volume can be set by rotating the
button (Priority is disabled when volume is set to zero)
- Press rotary button once again to return back to main menu
Paging volume for message from External Paging Console can be set.
- Set LED for corresponding zone to 'Bass'
- Hold rotary button for corresponding channel down for 3 seconds
(Bass LED starts blinking)
- Paging volume can be set by rotating the button
(Paging is disabled when volume is set to zero)
- Press rotary button once again to return back to main menu
Output signal for each zone can be switched between Mono and
Stereo
- While powering-up the device, hold the rotary buttonr for Zone 1.
The Mono / Stereo settings menu will be displayed
- Toggling between Stereo or Mono mode can be done by using each
zones' rotary button
- LED 1: Zone set to Mono
- LED 2: Zone set to Stereo
- Power off and Power on the device again to go back to normal
operation mode.
Connected wall panels can be assigned to one zone.
- Set LED for corresponding zone to 'Treble'
- Hold rotary button for corresponding channel down for 3 seconds
(All connected wall panels will start blinking)
- Press upper button from the wall panel to assign this wall panel to
the corresponding zone
- Repeat this action to assign multiple wall panels to this zone