F- Things That Must Be Done Before Calling Authorized Service; Troubleshooting - Ugur USM 2*10 Bedienungsanleitung

F- THINGS THAT MUST BE DONE BEFORE CALLING AUTHORIZED
SERVICE

Troubleshooting

The failures and solutions stated in this section can be performed easily by yourselves and always consult
to an Authorized Uğur Service if these suggestions do not solve your problem.
CAUTION!
• Intervention to any failure that may occur in your product must be carried out by Authorized Uğur
Service.
Any intervention that may be done by you may harm you, your employee or customer, invalidate the
product guarantee and cause material damage (fire etc.).
• In case of any failure, consult to Uğur Customer Care or Authorized Uğur Service.
Troubleshooting
Device not running
Device stops immediately
EN
after it starts
Device do not cool
Possible Solution
The fuse may be blown
It may not be plugged in
Integrated thermal fuse may
be blown
Air circulation is not sufficient
Condenser is very dirty
Fluctuation in voltage
Fan engine is not running
Recirculation pump is not
runnign
44
Result
Check the fuse
Inset the plug to a compatible
socket stated in this manual
Wait for a while
Provide a layout according to
the installation and placement
rules stated in this manual
Call for an authorized service
Check the voltage
Call for an authorized service
Clean the product as stated in
this manual