E - Cleaning, Maintenance And Transportation Of Your Fruit Juice And; Cleaning; Removing The Bowl - Ugur USM 2*10 Bedienungsanleitung

E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
FRUIT JUICE AND AYRAN COOLER

CLEANING

Cleaning of your device is composed of two stages, which are the internal cleaning and external cleaning.
Following warnings must certainly be abided before start cleaning.
CAUTION!
• Unplug your product before every cleaning.
• Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
• Never use domestic cleaning agents, abrasive and scratching substances (flammable and sparkling, solvent like
gasoline, thinner, acid) as cleaning agents. Otherwise loosening may occur in the plastic parts of your product.
Never use flowing and pressurized water for cleaning.
• Your product must be cleaned every day. Please read this section carefully for the hygiene of your product.
• If the area, where your product is installed, is wet and damp, external paint of your product may be damaged.
• It must be moved to somewhere free of humidity and damp
Remove the bowl from your product before start cleaning.

Removing the Bowl

• Take the switches to off position and unplug your product
• Remove the cover of the bowl
• Remove the pump inside the bowl by rotating clockwise
• Remove the spraying tube by rotating it.
• Remove the pump housing pin by removing the pin holding the pump propeller
• Lift the empty case up. Steep the metal cooler dome inside of the bowl for removing it easily.
• Remove the seal under the dome
• Remove the tap seal from its place by pressing on the button with "Push" indication
• For removing the tap lever, push the clip on the connection between the bowl and the tap. Open it by
rotating it to the left.
Placing the bowl
• Place the drip tray with its cover
• Insert the tap to its place
• Place the tap seal to its housing by pressing on the button written "Push" on it and ensure complete
fixing by pulling it down.
• Insert the pump again inside the bowl and fix tight by rotating counter clockwise.
• Insert the bowl seal
• Place the bowl onto its place together with the seal around the dome and push downwards for full fixing.
If the dome and seal are wet, it will be easier to insert and remove them.
41
EN