D- Using Your Fruit Juice And Ayran Cooler; Start-Up; Setting Internal Temperature Of Your Product - Ugur USM 2*10 Bedienungsanleitung

D- USING YOUR FRUIT JUICE AND AYRAN COOLER

Start-up

WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may
vary. There may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up (see page 17).
• If your product has been shaken so much during the transportation and positioning, wait for
one (1) hour without running your product. Thus, the compressor oil, which may enter into the
system, will return back. You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which
has been installed according to the regulations. (Picture 10)
PICTURE 10

Setting internal temperature of your product

There is a thermostat that controls beverage temperature in each bowl. Each thermostat is set at
our factory for achieving the desired coldness. When you want to set thermostat, please consult to
Authorized Uğur Service
You will hear a slight sound from the compressor when your pro-
duct is running.
At the front panel of your product, there is a switch controlling the
cooling system and a switch that controls a pump or a mixer for
each cooling bowl.
For both switches, position (1) means on (active) and position (0)
means off (stop).
After brining the power switch to position one (1), the switch of the
bowl, which is desired to be operated is pressed. When this opera-
tion is performed, the pump starts and the drink starts to circulate
inside the bowl
39
EN