C- Installation Of Your Fruit Juice And Ayran Cooler; Selecting The Place Of Installation - Ugur USM 2*10 Bedienungsanleitung

C- INSTALLATION OF YOUR FRUIT JUICE AND AYRAN COOLER

Selecting the place of installation

The operating environment of the product is very important for the smooth operation of your product. While selecting the
operating environment,
• Do not place your product exposed to outdoor environment (on the street, avenue etc.)
• Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.). (Picture 4)
• Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 5)
• Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to the cooler's glass. That means an
increase in the energy consumption.
• Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your product.
• While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and
back of your cooler.
WARNING!
In very humid environments, ensure that floor and wall of the place where the cooler is located, is not affected by
water; against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on
the suitable place for installation and make suggestion, but the consumer shall give the final decision on where
the installation will be made. This above mentioned process shall also be stated on the relevant installation form
by Authorized Uğur Service. In case of any loss arising from the place of installation of the product according to
the final decision given by the consumer, all responsibility related to such loss shall belong to the consumer.
EN
Consider the measures stated below while choosing a place for installation
Your product gives the best cooling performance according to the climate condition under the conditions given below.
Therefore, be careful that the temperature of the environment where your product will operate is at these levels.
In Commercial Products:
Climate Class
Class 3
Class 4
Class 5
Climate Class of your product is indicated on the technical
specification label on the product.
Temperature Range
16 °C to 25 °C
16 °C to 30 °C
16 °C to 40 °C
PICTURE 4
Humidity
60% Rh
55% Rh
45% Rh
36
PICTURE 5