Dab Mode - Denver DAB-24 Bedienungsanleitung

DAB MODE

If the radio is connected to the power and then switched on from standby for the first time, the radio
will automatically enter into the DAB auto tune full scan mode. During this mode, the display will
show a slide bar to indicate the progress of the scan.
Unlike normal radio, the separate signals from a number of stations are grouped together and
transmitted in a single frequency; these groups are referred to as multiplexes and ensembles.
Every time one of these groups has been found, the name of that group will be displayed on the
bottom half of the display.
Autotune modes
There are two types of auto tune modes, one is quick scan and the other is full scan. Quick scan will only
search for the UK DAB Band III channels and full scan will search all DAB Band III channels. Once the scan
has finished, the radio will select the first alphanumerically found station.
1. To activate the quick scan, press the AUTOTUNE button once, the display will show "Autotune Quick
scan" and then a progressing slide bar and "Searching...".(F4)
2. To activate full scan, press and hold the AUTOTUNE button until the display shows "Autotune Full scan".
(F5)
3. To explore the stations that have been found, press the UP or DOWN button.
Manual tuning
1. To select manual tuning, press and hold the SELECT button until the display shows "Manual
tune". (F8)
2. Press the UP or DOWN button to move through the DAB channels, on the top half of the display will
show "5A to 13F" and their associated frequencies. When your radio locates a station group (ensemble
/ multiplex) on one of the DAB channels, the name of the station group will appear on the bottom half of
the display. (F9)
3. To enter the ensemble/multiplex, press the SELECT button, the top half of the display will show the first
station in the ensemble/multiplex.
4. Press the UP or DOWN button to see what stations are present on the found ensemble / multiplex,
when you have located your desired station, press the SELECT button, and at the same time, you will
also exit from the manual tuning mode.
Auto select on / off
You can explore the found stations by pressing the UP or DOWN button, if the auto select is "ON", the
station will be automatically selected when the button is released, and the name of the station will be
displayed. If the auto select is "OFF", you have to press the SELECT button to switch to that station when
the display shows your desired station, otherwise it will revert back to the original station after 4 seconds.
To toggle between the auto select "ON" and "OFF", press the UP or DOWN button and then quickly press
and hold the SELECT button until the display shows the "Autoselect ON" or "Autoselect OFF". (F.10) (F.11)
F6 F7
F8 F9
F10 F11
UK - 4