Canon RS-CL17 Zusammenbau- Und Installationsanleitung Seite 8

2 Remove the screws from the four corners
of the projector top (4 positions).
● Two out of the four screws removed
will be used in Step 4-5.
Caution
3 Place the arm plates on the projector
top so that the holes on each corner
overlap with each other. Insert M6 spring
washers, and temporarily tighten them
with M6 screws (enclosed with RS-
CL15).
4 Adjust the positions of projector and base bracket as shown in the diagrams below.
● Make the gaps A and A' between the projector and base bracket parallel to each other, and with the
same widths.
● Make the protrusions of the four arms of the same lengths.
● If the position of the base bracket is not properly aligned against the projector and there is
a significant difference between the gaps A and A', the adjusted position may move out of
alignment over time.
Caution
5 Firmly tighten the M6 nuts attached to the arm plate B.
6 Firmly tighten the M6 screws attached to the arm plate A.
4
Attach the anti-fall wire
1 Fix each anti-fall wire (510 mm/20.1":
enclosed with RS-CL17) by fixing an M4
screw (with M4 washer and M4 spring
washer: enclosed with RS-CL15) through
an M6 washer (enclosed with RS-CL17)
to each of the two screw holes on base
bracket (C).
6
Top Side
A
A´
C
C