Canon RS-CL17 Zusammenbau- Und Installationsanleitung Seite 12

Separate the Joint fitting from the Ceiling-mount bracket temporarily
1
⇒ Preparation on page 5
Make a hole in the ceiling
2
Secure the Ceiling-mount bracket to the ceiling
3
Attach the Base bracket to the projector
4
Attach the anti-fall wire
5
6
Attach the top of the extension pipe
to the Ceiling-mount bracket
Secure to the extension pipe using the four
supplied M5 screws.
● The open end of the pipe should face the open
end of the Ceiling-mount bracket as shown.
Attach the Joint fitting to the bottom
7
of the extension pipe
Secure the Joint fitting using the four M5
screws (A) removed earlier.
10
⇒ Step 1 on page 5
⇒ Step 4 on page 6
Direction to the
screen
⇒ Step 2 on page 5
⇒ Step 3 on page 5
A
Direction to the
screen
A
Direction to the
screen