Chime Selection; Integration Into An Existing Door Bell System; Marking Panel; Important Instructions - REV Ritter . 0514949555 Bedienungsanleitung

5. Chime selection

You can set required chime using the selector switch ➃ :
TIP: If you are using further transmitters you can install differing signals using chime selection.
6. Chime Function
The radio-controlled chimes can be used upon completion of coding (see text no. 4) and installation
of the transmitter (fastening materials are included with the set). By pressing key ➆ the door chime
will sound for a short period with the chosen chime and the flashlight will blink. There are four set-
tings to change the tone via switch ➄ and four levels to adjust the volume of the chime via switch ➅ .

7. Integration into an existing door bell system

The radio-controlled chimes are suitable for integration into an existing door bell system. Two ope-
rating formats are available for this:
You have an existing door bell system with transformer and would like to operate the radio-control-
led chimes in another room parallel to the existing chimes (illus.
☛ Connect the contacts A and C of the transmitter  parallel to the existing door bell system .
If you have no function or an auto-repeat, switch terminals A and C over.
You have an existing door bell button and would like to operate this together with the radio-con-
trolled set (illus. ).
III
☛ Connect the contacts B and C of the transmitter  parallel to the existing door bell button .

8. Marking panel

Open the marking panel ➇ at the provided indentation and insert a written tab, e.g. with your
name, behind the clear cover. Close the marking panel by applying even light pressure to the clear
cover.

9. Important instructions

• The range between the transmitter and receive is max. 100m in an open area. The radio signal's
strength depends on constructional conditions when being transmitted through walls, panelling,
furniture and other obstacles – walls, in particular reinforced concrete walls and ceilings – lead
to a reduction in range.
• Reception can be severely impeded by screening from metal parts so that a transmission of the
signal is no longer possible. For this reason, never attach the transmitter  to a metal surface.
• To install, drill appropriate holes at chosen installation point and fasten the individual devices
into place using the provided fastening materials. Test the function of the device at the chosen
installation point first before completing final installation.
• Although the transmitter  is spray-water protected and therefore suitable for use outdoors, it
should not be subjected to direct sunlight for greater lengths of time as this can have a negative
effect on the colour and materials.
ANL_0514949555.indd 12
(a) 2-tone chimes
(b) 3-tone chimes
(c) Westminster chimes
).
II
15.11.2011 10:13:56