Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data; Battery Operation - REV Ritter . 0514949555 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

2. Technical data

Range:
Volume:
Tone:
Transmission frequency: 433MHz; 16 channels, freely selectable
Dimensions:
Batteries:
Protection type:
Transmission radiation takes place within the milliwatt range for just a few milliseconds when
the transmitter is activated and is not dangerous to health.
REV Ritter GmbH hereby declares that the models 14949 and 04444R2 is in accordance
with the underlying requirements and other relevant provisions of Directive 1999/EC. For the com-
plete CE Declaration of Conformity please refer to www.rev.biz under the article in question.

3. Battery operation

Remove the cover from the battery compartments ➀ + ➁ and insert the specified batteries – pay
attention to correct polarity (+/-).
Safety instructions for batteries
• Inserting the batteries the wrong way round (incorrect +/- polarity) can damage/destroy the
appliance
• Do not store batteries within the reach of children. This applies in particular to batteries that could
be swallowed
• Seek immediate medical help for affected person in the event of a battery being swallowed
• Do not attempt to revive batteries by heating up or similar measures. Primary batteries may not
be recharged as this can result in electrolyte leakage, fire and explosions
• Do not immerse batteries in water and do not store in a damp place. Always store in a dry and
cool place
• Do not throw batteries into fire. Do not attempt to open, solder or weld
• Do not short-circuit batteries
Please dispose of batteries in compliance with legal requirements (see section no. 13).
4. Coding
The transmitter  and receiver  must be assigned the same code first before you can operate
the receiver  by remote control. 16 different coding possibilities are available to ensure that the
receiver reacts without fail to the transmitter's signals. Open the cover of the battery compartment
on the transmitter ➁ and turn the switch ➂ to a position between 1 and 16 chosen by you. You must
turn the switch ➂ in the battery compartment of receiver  to the same position.
TIP: Test the required function before final installation at your chosen installation point (see text
no. 9).
ANL_0514949555.indd 11
max. 100m (in open area)
max. 80dB(A( (4 levels)
4 settings
receiver 167 x 82 x 70mm
transmitter 98 x 34 x 24mm
receiver 3 x 1.5V batteries LR 14 Baby C(not included)
transmitter 2 x 1.5V batteries LR03 Micro AAA (included)
Receiver IP20 – only suitable for use indoors
Transmitter - suitable for sheltered outdoor use
15.11.2011 10:13:56

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis