Inhaltsverzeichnis
Werbung
USE PROCEDURE
Controller Startup
To startup the controller plug the power cable into a
suitable power source and set the line switch to the
position 1.
Starting the pump
To start the pump press the START push-button on the
controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button on
the controller front panel.
MAINTENANCE
The Turbo-V 300 ICE series controller does not require
any maintenance. Any work performed on the controller
must be carried out by authorized personnel.
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
Controller 969-9433 and 969-9533 rear panel
WARNING!
1.
Logic
input
signals
supplied with link).
2.
Logic signals, pump current monitor and activation
frequency output connector.
3.
Power out socket (120 Vac, 1 A) for power supply to the
optional devices (vent device, primary pump activation
relay, etc).
4.
Pump cable socket.
5.
Controller power entry module consisting of mains fuses,
voltage change over, mains socket and EMC filter.
6.
Heater jacket power cord socket.
7.
Provision for RS-232 - RS-422 - RS-485 communication
port connector (provided as an option).
8.
Power switch.
9.
Heater jacket power supply fuse.
10. Flow meter connection cable socket.
11. Ground connection.
If a pump is to be scrapped, it must be disposed off in
accordance with the specific national standards.
Meaning of the "WEEE" logo found in labels
The following symbol is applied in accordance with the
EC WEEE (Waste Electrical and Electronic Equipment)
Directive.
This symbol (valid only in countries of the European
Community) indicates that the product it applies to
must NOT be disposed of together with ordinary
domestic or industrial waste but must be sent to a
differentiated waste collection system.
The end user is therefore invited to contact the supplier
of the device, whether the Parent Company or a
retailer, to initiate the collection and disposal process
after checking the contractual terms and conditions of
sale.
67
INSTRUCTIONS FOR USE
connectors
(mating
connector
DISPOSAL
87-900-902-01 (L)
Werbung
Inhaltsverzeichnis
