Connecting Euroblock Plugs (Mm-2D-E Only) - Tascam MM-2D-E Bedienungsanleitung

DATA/DATA+PoE connectors
9
These are Dante transmission connectors.
Use to connect the unit to a Dante network.
Use the DATA+PoE connector when connecting to a
switching hub that supports PoE power supply. In this
case, use of an AC adapter is not necessary.
Either connector can be used when using a switching
hub that does not support PoE power supply.
RESET button
0
This resets the settings.
Press and hold for 5 seconds to reset all Dante settings.
Press and hold for 10 seconds to reset all unit settings.
External control connectors
q
(LED/SWITCH, MM-2D-E only)
LED
connectors: These are open collector mute status
output connectors.
SWITCH
connectors: These are control input connec-
tors. These mute the audio signals
from the analog input connectors.
These can also be used by operat-
ing (short/open) a switch connect-
ed between the
connectors.
GND
connectors: These are grounds for the control con-
nectors.
External control connectors
w
(CONTRO, MM-2D-E only)
By connecting variable resistors between the
GND
and connectors, the selected audio signal levels
can be adjusted.
The 10V connectors are for supplying power to variable
resistors.
(Left is 10V, center is CONTROL and right is GND.)
Gigabit link status indicator
e
Orange indicates that a gigabit Ethernet link has been
established.
Link status/activity indicator
r
Green indicates that a link is established between the
devices.
Blinking indicates that signals are being transmitted be-
tween the devices.
DC IN 12V connector
t
Connect a PS-P1220E AC adapter (sold separately) here.
Cord holder
y
When using a PS-P1220E AC adapter (sold separately),
hook its cord here to prevent accidental disconnection.
Connecting Euroblock plugs
(MM-2D-E only)
Euroblock plug tab
SWITCH GND
and
1.
NOTE
Use a flat-blade screwdriver with a width of 2.5mm or
less.
CONTROL
2.
NOTE
AWG16–AWG28 wires are compatible with the includ-
ed Euroblock plugs. Using wires within the compatible
range, trim about 7 mm of the protective sheaths from
their ends.
3.
NOTE
Confirm that the wires cannot be pulled out.
4.
2.5 mm or less
Terminal screw
Euroblock plug
Loosen the Euroblock plug terminal screws.
Insert wires.
Tighten the Euroblock plug terminal screws.
Use an included wire band to attach the wires to the
Euroblock plug tab.
TASCAM MM-2D-E / MM-2D-X
Flat-blade screwdriver
9