Dsp Overview; Input Channels; Mixer; Output Channels - Tascam MM-2D-E Bedienungsanleitung

Setting the reference level
You can set the analog input and output headroom (differ-
ence between the maximum and reference levels).

DSP overview

This unit has a built-in DSP mixer. A variety of audio pro-
cesses suitable for different applications and conditions are
available.
All of the following settings can be made using the dedi-
cated remote control application (TASCAM DCP CONTROL).
See the back of this manual for DSP block diagrams.

Input channels

Input polarity setting
Set according to the polarity of the input channel signal.
Compressor
When the input volume exceeds the THRESHOLD level, the
input volume is compressed, reducing output volume vari-
ation.
Input equalizer
This unit has 4-band equalizers for the input channels.
Use the equalizer to increase or decrease the levels of spe-
cific frequency ranges. This can be used, for example, to
enhance the sound of individual instruments, to adjust the
balance of a wide frequency range and to cut specific un-
wanted frequencies.
Automatic level control function
When the input sound level is too low or too high, the input
level will be increased or decreased automatically to an ap-
propriate level.
Input channel fader
Adjust the level sent to the mix bus.
Input mute
Mute the input channel signal.

Mixer

Matrix mixer
This unit has simple matrix mixer functions.
Ducking function
When a mic signal is input, the ducking function can auto-
matically lower the volume of background music or other
sound input through the line input channels.
Ambient noise compensator (ANC) function
The ANC function can measure ambient noise and auto-
matically adjust the volume to make the main sound source
easier to hear.
Routing setting
Audio can be routed to multiple output channels through
the matrix mixer, the ducking function and the ANC func-
tion.

Output channels

Output equalizer
This unit has 10-band equalizers for the output channels.
Use the equalizer to increase or decrease the levels of spe-
cific frequency ranges. This can be used, for example, to
enhance the sound of individual instruments, to adjust the
balance of a wide frequency range and to cut specific un-
wanted frequencies.
Delay function
Use to adjust the delay of output channel signals.
Output channel fader
Use to adjust the level sent to the output jack.
Output mute
Mute the output channel signal.
Output limiter function
This prevents distortion caused by sudden excessive output
signal levels.
Output polarity setting
Set according to the polarity of the output channel signal.
TASCAM MM-2D-E / MM-2D-X
11