Application Overview; Notes About Dante; Connecting To A Dante Network; Switched (Daisy Chain) Connection - Tascam MM-2D-E Bedienungsanleitung

Application overview

Using the TASCAM DCP CONNECT remote control applica-
tion, you can operate the unit from a distance.
For details about the application, please see its Owner's
Manual.
You can download the application Owner's Manual from
the TEAC Global Site (http://teac-global.com/).
INPUT screen

Notes about Dante

Dante is a transmission protocol developed by Audinate.
Using networks based on gigabit Ethernet standards, it en-
ables multichannel (512 IN/512 OUT) transmission and high
precision, for example.
Check the Audinate website for details about Dante.
https://www.audinate.com/
12
TASCAM MM-2D-E / MM-2D-X

Connecting to a Dante network

In order to set up and use this card, you must also set up the
Ethernet network that it is connected to, a computer that
runs Dante Controller and other devices that support Dante.
Requirements for LAN cables used for con-
nections with the connectors on this unit
Use STP cables that are at least category 5e.
Both crossover and straight cables can be used.
ATTENTION
This unit is not compatible with 100Mbps Ethernet
switching hubs. Always use switching hubs that support
Layer 2 and Gigabit Ethernet.
NOTE
i Set the computer to set the IP address automatically.
i Restarting the computer might be necessary if a previ-
ous network setting is still active on the computer.

Switched (daisy chain) connection

Dante devices can be daisy-chained when there are few
connected devices and when not using a switching hub.
Connect them as shown below.
Switched (daisy chain) connection example
Mixer
NOTE
i When using a switched (daisy chain) connection, either
DATA DATA+PoE
or connectors can be used.
i If the number of connected devices increases, raising the
latency setting will be necessary.
MM-2D MM-2D