Before You Begin; Required Tools; Assembly Instructions (Pro Model Only) - Razor Cruiser Gebrauchsanweisung

BEFORE yOU BEgIN

Remove contents from box. Inspect the contents of the box for scratches in the paint and/or dents that may have
occurred during shipping. Because your scooter was assembled and packed at the factory, there should not be any
problems, even if the box has a few
scars or dents.
Grip
T-tube
Collar clamp
Front fork
Wheels
q Required Tools
5mm
Allen wrench
ASSEMBly INSTRUCTIONS (PRO MODEl
1
Loosen the collar clamp and
slide it upward. With a clock-wise
twisting motion, push and "thread"
the extension tube onto the fork
until it bottoms out on the fork
headset lock nut.
Handlebar
Steering tube quick-release
Steering tube/steering column
Joint lever/pivoting mechanism
Rear fender/brake
Deck
Steering column adjusting screw
2
With the front wheel pointed
straight ahead and the handle-
bars square to the front wheel,
tighten the clamp as shown.
Tighten securely.
2
WARNINg: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
ONly)
TM
WARNINg: Failure to
properly install and tighten the
collar clamp may cause the rider to
lose control and fall. If you do not
understand these instructions or
the concept of "tighten securely"
seek the assistance of a qualified
mechanic.