Connecting An Existing Camera - Silvercrest HG03107 Montage-, Bedienungs- Und Sicherheitshinweise

Select "Indoor Pan Tilt Camera" .
Tap "Configure a new Camera" .
Tap "Next" .
Tap "Next" . The application searches for the
camera by its identification code (DID) .
NOTE: The DID code is located under the
QR code sticker on the main unit (near to the
rating plate) .
Once the camera has been found, assign a
name to the camera and set a new admin
password .
NOTE: For your own privacy and safety, you
are required to setup a secure 12-digit password
consisting of uppercase and lowercase letters,
numbers, and special characters . Keep the
password well for future need .
The setup process brings you to the Wi-Fi
connection setup .
The Wi-Fi router default password is usually
labelled at the back of the router . If you have
changed the default password to a custom
one, make sure the password is correct before
you start the Wi-Fi setup of the camera .
NOTE: If the camera cannot be found,
it may have been already added . Go to the
"Connecting an existing camera" section . Input
the DID code manually or use the QR code scan .
The DID code is located under the QR code
sticker on the main unit (near to the rating plate) .
Then, input the correct security password (same
password as from the initial configuration) . If
there is still no connection found, reset the camera
by pressing the RESET button
Afterwards, follow the on-screen instructions of
the app to reset the camera .
10
for 5 seconds .

6. Connecting an existing camera

Open the application on your smart device
and tap icon to connect to the camera .
NOTE: Follow the installation steps of the
app during Wi-Fi setup .
Select "Indoor Pan Tilt Camera" .
Tap "Connect an existing camera" .
Type in the camera name .
Type in the DID code, or tap
the QR code located on the bottom side of the
camera .
Confirm the selection by tapping "Next" .
Type in the password .
Tap "Next" .
NOTE: If you plan to connect to an existing
camera with a different smart device, use the
same login credentials (name/password) as set
on the first smart device .
icon to scan
GB/IE 35