Getting Started - Silvercrest HG03107 Montage-, Bedienungs- Und Sicherheitshinweise

˜ Getting started
1. Installing the microSD card
(not included)
If you intend to record videos, install a microSD
memory card .
Push in the microSD card against the spring,
pins down, until it locks in place .
Removing the microSD card: First gently push
the card in and then pull it out .
NOTE: We recommend to use a
Class 10 rated microSD card or higher . A low
speed card can be damaged during high speed
FHD (full high definition) recording .
2. Positioning the camera
NOTE: For alignment of the camera all laws
of the country of usage have to be observed .
NOTE: Cordless systems are exposed to
interference of telephones, microwaves, as well
as other electronic devices operating in the
2 .4 GHz range . Maintain a minimum distance
of 3 metres from those devices during installation
and operation .
Adjust the camera angle to the desired
position . You may also use the pan and tilt
function to do so .
3. Connecting the cables (Fig. C)
Plug the LAN cable
17
port .
11
Connect the plug of the power adaptor
the connection for the power adaptor
Plug the power adaptor
appropriate power supply .
The status LED 6 lights up green (indication
that the product is connected to the power
supply) .
After approximately 45 seconds, the status
LED starts flashing in green colour
6
(indication that the product is ready to start
the installation process) .
34 GB/IE
into its connection
to
15
.
7
into an
15
4. Router (Fig. C)
NOTE: Before you can use the camera
wirelessly, it must be set up through a cable
connection .
Preparation:
–Check if your router (not included) has an
active internet connection .
–Connect your smart device with the router .
–Read your router's instruction manual, if
needed .
Connect the LAN cable
the router .
NOTE: The camera needs about 1 minute of
a startup time after it is powered on . The product
is ready for setup when the status LED
continuously in green colour .
5. Configuring a new camera
Download and install the "Silvercrest IP Cam
S-K 1920" application on your smart device .
The application is available in the App Store
for iOS devices and in the Google Play
store for Android devices .
Alternatively scan the appropriate QR code
for your smart device operating system:
Open the application on your smart device
and tap icon to add the camera .
NOTE: Follow the installation steps of the
app during Wi-Fi setup .
to a free slot on
17
6 flashes
®
TM