Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Heating plates (top and bottom)
2.
Upper lid
3.
Base of the appliance
4.
Thermostat knob with temperature
control
Plates covered with non-stick coating.
BEFORE FIRST USE
Before the first use, wash thoroughly the heating plates of the waffle-maker
cloth and wipe clean.
NOTE! Before cleaning the heating plates make sure the appliance is unplugged!
NOTE! When the waffle maker is turned on for the first time, it may release some smoke. This will pass in a few
minutes of heating. The first waffles made with the brand-new waffle maker are not recommended for eating.
USING WAFFLE-MAKER
1. Oil the heating plates
2. Plug the waffle maker to the mains. The indicator lamp
is connected to the mains. Turn the temperature control knob
become hot, and while the process continues, the indicator lamp
lid and ready the batter for the waffles.
3. When the waffle maker reaches the set temperature, the indicator lamp
the temperature of the hot plates with
LOW is about 130°C. HIGH is about 230°C. You can set the temperature anywhere between
LOW and HIGH. The indicator lamp
the deep fryer is maintaining the set temperature.
4. Open the top lid
2
lid.
5. When closing and opening the lid, proceed carefully owing to hot vapours escaping from the
sides of the waffle-maker.
6. Baking the waffles may take from 5 to 10 minutes, depending on the batter and set temper-
ature.
7. Open the top lid
2
NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces may occur!
8. After baking turn the thermostat knob to "0", pull out the plug from the outlet and allow the
appliance to cool down completely.
CLEANING AND MAINTENANCE
1. Before cleaning (and after baking), pull out the plug from the outlet and allow the appliance
to cool down completely.
2. Thoroughly wash the heating plates
3. Wipe the external surface of the waffle-maker using wet cloth.
with butter, margarine or other fat.
1
4
6
will go on and off during operation. This means that
, place the dough onto the bottom heating plate
, take out the waffles using wooden or plastic spatula only.
using damp cloth or towel.
1
5.
Power supply indicator
6.
Thermostat indicator
7.
Non-slip feet
5
will be on when the waffle maker
4
to (High). The hot plates will
according to the batter and the doneness level.
with a damp
1
6
will be on. Close the top
6
will be off. Adjust
and gently close the
1
11
Werbung
