Herunterladen Inhalt Inhalt Diese Seite drucken

Infrared Controller; Cleaning And Maintenance; Environmental Protection - Maestro MR 927 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
ATTENTION!
- Never clean appliance connected to the mains.
- Before cleaning, disconnect the heater and let it cool down.
- Do not use abrasive and aggressive detergents.
- Never submerge the heater, power line cord and plug in water or other liquids. Do not allow water
and moisture on the electrical parts of the device.
- The outside case can be cleaned using a slightly damp lint-free cloth [a small amount of detergent
can be used if required].
- Always make sure the machine is completely dry before using.
- To remove any dust particles etc. from inside the front grill, or the rear air intakes, you can use
a regular vacuum cleaner and a soft brush.
-There are no parts inside the machine that require your attention or servicing. Do not try to open
the outer case. By doing so you could damage the motor and heating element and invalidate
the warranty. Any other maintenance should be performed by qualified personnel in the service center.
- Before storage, disconnect the heater let it cool down.
- Wipe and dry the heater before storage.
- Do not reel up the power cord around the appliance before it is cooled completely.
- Store the heater in a cool, dry and clean place beyond the assess of children and people with limited
physical and mental abilities.
Old appliances contain valuable materials that can be recycled.
Please arrange for the proper recycling of old appliances. Please dispose your old appliances using
appropriate collection systems.
Subject to technical modifications!
8
Infrared controller, please use 2 battery.
7.Press " " as follows: ON(only Fan working),
OFF(Fan keep working for 30 seconds when shutdown
the appliance after heating)
8.Press "HEAT" as follows: Low heat, High heat, FAN working.
9.Press "SWING" as follows:, SWING ON, SWING OFF
10.Press "TIMER" to set timer as follows: 1H,2H,3H.....8H
11.Press "TEMP"to set temperature, Temperature range :10-45 °С;
Note: The indicator lights when corresponding function is working

Cleaning and maintenance

Storage

Environmental protection

Infrared controller

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis