Change The Print And Retransfer Ribbons; Change The Print Ribbon; Remove The Print Ribbon - Rimage Professional 5410N Benutzerhandbuch

Change the Print and Retransfer Ribbons

This section provides the information needed to change the print and
retransfer ribbons in the integrated Everest 400 printer. Change a 3-color
(CMY) print ribbon after 500 discs, a 4-color (CMY+W) print ribbon after 325
discs, a back (monochrome) print ribbon after 1000 discs, and the retransfer
ribbon after 500 discs.
Tip: For more detailed instructions on replacing the print and retransfer
ribbons, refer to our YouTube channel at
RimageCorp for instructional videos.

Change the Print Ribbon

Before you change or first install a new Everest print ribbon, allow time for
the new ribbon to become acclimated to the environment. Allow more time
for greater temperature and humidity differences.
Important!
Rimage supports only the use of Rimage brand ribbons in our printers.
•
Printer issues that occur as a result of using ribbons from manufacturers
other than Rimage are not included under your Rimage warranty or
maintenance agreement.
For optimum results, make sure that Everest ribbons are stored at a
•
temperature between 41° and 95°F (5° to 35°C) and humidity level
between 45% and 85%.
Avoid moisture and direct sunlight.
•
Do not reuse ribbons.
•
Use only ribbons designed for your model of Everest 400 printer.
•
The ribbon carriers cannot be removed from the printer unless the
•
system is powered on.

Remove the Print Ribbon

1. Open the side cover on the left side of the
autoloader.
a. Lift the printer cover latch to open the
printer cover.
b. Lower the printer cover.
2002552_B
www.youtube.com/user/
Printer Cover Latch
Printer
Cover
Left Side of Autoloader
For more information visit
2. Access the print ribbon.
a. Turn the center latch counterclockwise to unlock it.
b. Pull the print ribbon carrier all the way out of the printer.
Important! The ribbon carriers cannot be removed from the printer
unless the system is powered on.
Tip: Perform cleaning procedures while the print ribbon is removed.
For more information refer to the
Printer
section on page 26 or refer to our YouTube channel at
www.youtube.com/user/RimageCorp
Print
Ribbon
Carrier
c. Lay the print ribbon carrier on its back. Place the carrier on a flat
surface.
Tip: To keep the print ribbon carrier in place while you remove the
print ribbon, position the carrier so that the tab rests on the edge of
a table or workspace.
Print
Ribbon
Carrier
rimage.com/support
Clean the Everest 400
for instructional videos.
Center Latch
Tab
19