Power On The System - Rimage Professional 5410N Benutzerhandbuch

Operate the Professional 3410 and 5410N System
This section provides the information needed to operate your system.

Power On the System

1. Press the power switch on the rear of the autoloader. The system
powers on, including the integrated printer.
If you have an 5410N, continue with step 2.
Power Switch
2. On the front of the 5410N, press the PC power button to power on the
embedded PC.
PC Power Button
Power Off the System
1. Close all open applications.
2. If you have a 5410N, press and release the PC power button. This shuts
3. Press the main power switch on the back of the system to power off the
For more information visit rimage.com/support
down the software, Windows, and the embedded PC.
If you have a 3410, continue with step 3.
Caution: Do not press and hold the PC power button. If you press
n
and hold the PC power button, the embedded PC will not shut down
properly. This may cause data loss or corruption.
system, including the integrated printer.
Important!
Do not press the power switch until the embedded PC is completely
•
powered off.
It takes approximately 30 seconds for the system to power off.
•
If the printer is idle for more than 30 minutes, it enters sleep mode.
•
When this occurs, the printer will take up to 6 minutes to warm up
after a job is sent.
12