Accessories; Possible Cause - ZUMEX Essential Basic Bedienungsanleitung

Accessories

There is a wide range of accessories available for you to make the most of your
machine:
1Step Extraction Kit
With this accessory you will be able to dismantle the machine in just 10
seconds and clean it under the tap or in the dishwasher.
* Including juice extraction system.
Kit S / 1Step Extraction Kit S
To juice fruit that has a diameter of 45 mm to 67 mm.
Countertop Kit
Integrates waste management keeping things practical and clean.
Elevation kit
This Zumex machine has an Elevation Kit to make it easier to clean the
surface where it is located.
Bottle set
For self-service restaurants - bottles, glasses or jugs of juice can be
distributed easily. Includes three trays (4 heights). It is integral to the
podium and the whole set can be transported with ease.
Zumex Pack
Fresh drinks can be packaged for commercialization, especially freshly
squeezed orange juice. There are 6 formats (1.5 l, 1 l, 75 cl, 50 cl, 33cl and 25
cl) and custom-made stickers.
Check www.zumex.com for more information on accessories for your
machine.
Detecting Faults
Fault

Possible cause

The machine doesn't work Machine not plugged in.
No power is reaching the plug.
Cover not fitted properly.
Juice container not fitted
properly.
Blocked pressing units.
Safety sensors malfunctioning.
Faulty ON/OFF button.
Faulty circuit.
The machine blocks Insufficient voltage.
frequently during juicing
Faulty circuit.
The pressing units are not Fault in an axle.
synchronized
Peel ejector breaks Peel ejector incorrectly fitted.
You can hear the motor
Internal fault.
running but the pressing
units are not turning
EN
Correction
Plug it in.
Check the socket.
Make sure it has been fit
properly.
Make sure it has been fit
properly.
Turn off the machine at the
mains and unblock the pressing
units.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Check that the voltage matches
that indicated in the manual.
Contact your technical service.
Contact your technical service.
Place it in its correct position
inserting it totally until
observing it has madecontact
(Fig. 8)
Contact your technical service.
31