Inhaltsverzeichnis
Werbung
Introduction
1.
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken
to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, don't install or use it and contact your dealer.
General Guidelines
2.
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
•
Protect this device from shocks and abuse. Avoid brute force when operating the device.
•
Protect the device against extreme heat and dust.
•
Familiarise yourself with the functions of the device before actually using it.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• DO NOT use this product to violate privacy laws or perform other illegal activities.
Features
3.
• vandal-proof housing design (IPxx7)
• low light sensitivity (0.05 lux @ F1.4)
• super high resolution
• f3.8 ~ f9.5mm varifocal lens
Operation
4.
•
Open the dome camera: hold the base and turn the plastic dome anticlockwise.
•
Remove the protective cap: releasing both screws [C] (on opposite sides). Gently press on the
sides to lift the cap.
•
Mount the dome camera in the desired location: rotate the lens plate to align the gaps and
mounting holes. Use the base as a template for the mounting holes. Fix with 3 screws (not
incl.).
•
Connect the video output [2] and Power input [1]. Use a regulated 12Vdc power adaptor (not
incl.).
•
Point the camera towards the field of interest: gently change the tilt angle of the camera (max.
90°) and rotate the lens plate (max. 60°).
•
Release screw [A] until the housing can be moved and set the desired zoom factor.
•
Tighten screw [A] hand tight. Do not force to avoid damage to the mechanism.
•
Release screw [B] until the housing can be moved and set the desired focus.
•
Tighten screw [B] hand tight. Do not force to avoid damage to the mechanism.
•
Place the protective cap back (make sure it doesn't cover the lens) and secure both screws [C].
•
Screw the plastic dome back in place (clockwise).
01/07/2011
CAMCOLD21
User manual
3
©Velleman nv
Werbung
Inhaltsverzeichnis
