Package Contents/Parts List (Fig. A); Technical Data; Intended Use; Safety Instructions - Zoofari 311225 Gebrauchsanleitung

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following
instructions for use.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Package contents/parts list
(Fig. A)
1 x bed area (1)
1 x sun roof (2)
2 x long rods (3)
2 x cross rods (4)
4 x feet (5)
4 x long connecting rods (6)
1 x short connecting rod (7)
4 x connectors (8)
2 x triangle connectors (9)
1 x instructions for use

Technical data

Dimensions: Bed area: approx.
106 x 20 x 75cm (W x H x D)
Total dimensions (bed area and sun roof): ap-
prox. 106 x 85 x 75cm (W x H x D)
Max. capacity: 60kg
60
Date of manufacture (month/year):
03/2019

Intended use

The product is not intended for commercial use.
The product can be used as an indoor and
outdoor bed for dogs.

Safety instructions

Important: Read these assembly instruc-
tions carefully and keep them in a safe
place!
Risk of death!
• Never leave children unattended with the
packaging materials. There is a risk of suffoca-
tion.
• Keep children away from the product.
• The product is not a toy or a climbing ap-
paratus! Make sure that persons, especially
children, do not stand on the product or pull
themselves up on it. The product can topple
over.
Risk of injury!
• Make sure the product is properly stabilised
before using it!
• Place the product on a solid and level surface.
Do not place near stairs.
• Do not place hazardous items, such as can-
dles, on or near the product.
• Check the product regularly for wear. Check
regularly to make sure all connections are
tight! The product should only be used if it is in
perfect condition!
• The product may only be used for its intended
purpose.
• Do not exceed the maximum carrying capaci-
ty.
Assembly
1. Remove the packaging and lay all the parts of
the product out on the floor (Fig. A).
2. Put the long rods (3) and the cross rods (4)
through the loops on the bed area (1).
3. Connect the ends of the long rods and the
cross rods with a connector (8) each (Fig. B).
Note: See Figure B. The small opening to insert
the sun roof must be facing upwards.
4. Put a foot (5) under each of the connectors
(Fig. C).
The dog bed is now completely assembled.
5. Slide the long connecting rods (6) through the
loops on the sun roof (2) (Fig. D).
GB 13