Troubleshooting - Ribimex Ribitech RIPE12V/TI Handbuch

TROUBLESHOOTING

TROUBLES
The motor runs in only one
direction
Motor runs but overheats,
Motor runs but with
insufficient power or at low
speed.
Motor runs, but drum does
not turn.
Motor will not operate.
Motor damaged by water. The motor has been
STORAGE
Product must be stored in a dry location. Always lock up product and keep out of reach of children
CAUSES
- Defective or blocked
solenoid.
- Defective remote control
switch.
- Long period of
operation.
- Insufficient battery
- Bad connection.
- Insufficient battery
charger system.
- Clutch not engaged.
- Defective or blocked
solenoid.
- Defective remote control
switch.
- Defective motor
- Loose connections.
submerged in water or
washed with high pressure
water.
REMEDIES
- Shake solenoid to free contacts Check by
applying 12Volts to coil terminal (it should
make an audible dick when energized), -
Disengage winch clutch, remove îhe
remote control switch plug. Motor should
- Cooling-off periods are essential to
prevent overheating.
- Check that the battery terminal voltage
under load is 10 Volts at least, replace the
battery or add another.
- Check battery cables for corrosion, clean
or grease.
- Replace with a larger capacity battery
charger system.
- If the clutch is engaged but the symptom
persists the winch must be disassembled to
determine the cause and repaired.
- Shake solenoid to free contacts Check the
solenoid by applying 12 Volts to coil
terminal (it should make an audible click
when energized).
- Disengage winch clutch. Motor should
run.
- If the solenoid operates, check for voltage
in the core, replace motor.
- Tighten connection on lower side of the
cover and on the motor.
Allow to dry thoroughly, then run motor
without load in short bursts to dry windings
Page 21 of 53