Loading Foodstuff To Your Product - Ugur UDD 100 SC Bedienungsanleitung

D- USING YOUR PRODUCT

Loading foodstuff to your product

You can load your foodstuff after running your product empty for three (3) hours (If your product is a thermo-
meter installed model, you can control internal temperature of your product from here.)
UYARI!
Before loading your device with foodstuff, run your cooler empty for three (3) hours.
Do not load your product with food over the loading line.
Defrosting
Your product has manual defrost.
If there is excessive frost deposit on the walls of your device, this will lead decrease in the cooling capacity
and increase in energy consumption.
Clean the walls with frost deposit by means of a frost shaver supplied with the device without damaging
the walls.
If the frost deposit and its thickness are high, place the products inside of your device to another suitable
environment that prevents them to get spoiled.
EN
Unplug your product. Frost deposit generally melts in two (2) hours.
Place a container at water discharge for preventing the melted ice waters to damage the floor.
After defrosting operation, wipe internal walls with a dry cloth to make sure that they are not wet.
Run your device empty again for three (3) hours and wait for it to cool down. Then you can place your
foodstuff in it.
50