Clock Setting - LEXIBOOK CS100 Bedienungsanleitung

Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable bat-
teries are only to be charged under adult supervision. Different types of bat-
teries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to be
inserted with the correct polarity. Exhausted batteries are to be removed from
the product. The supply terminals are not to be short-circuited. Do not throw
batteries into a fire. Remove the batteries if you are not going to use the prod uct
for a long period of time. Batteries shall not be exposed to excessive heat such
as sunshine, fire or the like.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur,
remove the batteries and insert them again.
Power with USB port
Your olfactory alarm-clock also operates on DC 5V
500mA with a micro USB cable (not included).
1. To power on your alarm clock, insert one end of the
USB cable into the micro USB port located at the
rear of the unit.
2. Connect the other end to a USB port or a power
transformer.
Note: the USB cable does not recharge the olfactory
clock.
Note: All saved settings (time, alarm, etc.) in the alarm-
clock will be automatically lost when batteries or power
source are removed for a minute or more.
How to put the capsule
Fill your olfactory alarm-clock with the capsule
included in the pack and ensure it is fully inserted
into the capsule slot (8).
Note: A capsule lasts for 30 awakenings. The length
of use may diminish in case the scent diffuser has
been used outside the alarm mode.
Where to find your fragrance capsules ?
Discover the different fragrance capsules online at
www.lexibook.com
1. To set the clock, press and hold
2. Press
3. Press
4. Press
CS100IM1337_101_V09.indd 8

CLOCK SETTING

/ to set 12H or 24H display. Confirm using
/ to set the hours. Confirm using
/ to set the minutes. Confirm using
until the time starts blinking.
.
.
.
8
18/8/17 2:55 pm