Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the product. These factors can only be guaranteed by the people who
maintain and operate the fan.
Assembly instructions
1. Loosen the blade attachment nut of the motor axle, and the four rear gri-
lle attachment screws, located on the head of the motor. (figure 1).
2. Assemble the rear protection grille on the motor head, making the 4 gri-
lle holes coincide with the 4 motor head holes, and secure the grille with
the previously removed screws.
3. Introduce the blade in the motor axle, adapting the axle plane in line with
the blade plane, and securing it by way of the blade attachment nut.
4. Check the blade by turning it manually. If it does not rotate freely, repe-
at the operations above.
5. Assemble the front protection grille. Introduce the two pins in the rear
grille, bring the two grilles together and apply pressure until they are
secure within the plastic ring.
6. Lock the safety clip in position on the lower part of the front grille, and
secure it with the screw.
Installation of the fan on the ceiling
- Ensure that the ceiling where the fan is to be located is of sufficient
strength to support the total weight (4 kg) and the oscillation of the fan.
- Loosen and remove the two indicated safety screws. (figure 2)
- Rotate the metallic support clockwise until the two attachment points
come up over the slots. Use the metal support as a template to mark the
four central holes (figure 3). Remember the power supply cable input.
- Make four holes with a Ø6 broach.
- Attach the metallic support to the ceiling, using the screws and plugs
provided with the device.
- Proceed with the electrical connections for the equipment, following the
recommendations described in the following point.
- Once again position the fan in the ceiling support and secure it using the
safety nuts.
16
17
Werbung
