Switching On/Off; Locating - Loc8tor Tabcat Bedienungsanleitung

SWITCHING ON / OFF
ON
• Hold in the right hand side button (see Button Guide) for 2 seconds.
• The Tabcat will bleep and all the lights flash.
• Small status light will flash whilst on.
• The Tabcat will automatically power down after 45 seconds if left idle.
OFF
• Hold in the right hand side button for 2 seconds. Tabcat will beep and turn off.
VOLUME
Press in the left hand side button to select from three volume settings; Off, Low or High.
An audio beep will sound when pressed indicating the current volume level.
TIPS
• Write on the sticky label provided which button is allocated to each Tag / item.
• If a locate button is pressed with no Tag assigned to it an error tone will sound and the status lights
will blink rapidly. To register a Tag to this button, complete the steps 'REGISTER A TAG'.
6
LOCATING – SEARCHING FOR A PET
LOST
• Press and hold down the ON button until the Tabcat beeps and lights flash.
• Press the button that your cat / Tag is allocated to.
• Tabcat will beep and status light will flash rapidly as it's searching for the Tag.
• When a Tag is detected the locating lights will light up and the audio will start.
• With the Tabcat in your hand and pointing forward turn around slowly completing
• As you point in the right direction and then move nearer to the item, the audio
• Once a circle has been completed, face in the direction of the strongest audio
• When you see three green lights the Tag is very close by.
• To guide you right in, the Tabcat now changes to 'zooming in' mode (pictured).
• As you get closer in (zooming in) mode, amber then red lights also illuminate
FOUND
To stop a search press the ON/OFF button, or the locate button your Tag is allocated to.
www.mytabcat.com www.mytabcat.com
a full circle.
pitch and frequency of beeps will increase, and lights on the Tabcat change
from red to amber to green.
and visual signal and walk in that direction.
and the audio pitch increases.
7