Getting Started; Step 1: Inserting Batteries Into The Digital Pen - Silvercrest SGT 10.6 A1 Bedienungsanleitung Und Serviceinformationen

Getting started

Proceed as follows to start using your graphics tablet quickly and easily.

Step 1: Inserting batteries into the digital pen

To insert batteries proceed as follows:
SilverCrest graphics tablet SGT 10.6 A1
1. Remove the cap.
2. Push the cover upwards slightly
and lift it off.
Do not push the cover too far
upwards, as the tabs at the front
could otherwise break off.
3. Remove the film from the sup-
plied battery and insert the bat-
tery. The plus pole (+) must al-
ways point towards the open end
of the pen.
Ensure batteries are always
inserted with the correct polarity.
4. Place the tabs of the cover into
the front of the bottom section
and carefully push down until the
cover snaps into place on the
bottom section. Do not use any
force.
5. Replace the pen cap.
English - 11