Troubleshooting - Campingaz 4 Series Classic WLD Bedienungsanleitung

V. TROuBleSHOOTIng
Problems
The burner will not light
Burner 'pops' or blows
itself out
Sputtering unsteady flames
Large flames on surface
of burner
Flame low on jet
Excessive grease flare-up
Burners light with a match,
but not with the "PIEZO"
igniter
Fire at any connection
Lack of heat
Fire behind control knob
Fire under control panel
Probable causes / remedies
y Lack of gas supply.
y Regulator does not work.
y Hose, valve, Venturi tube or burner openings are blocked.
y Venturi tube not seated over jet.
y Check gas supply.
y Check hose connections.
y Contact the After Sales Service.
y New bottle may contain air. Continue use and the problem will disappear.
y Contact the After Sales Service.
y Jet nozzle badly connected to Venturi tube. Adjust the Venturi tube.
y The Venturi tube is clogged (e.g.: cobwebs). Clean Venturi tube.
y Contact the After Sales Service.
y The bottle is almost empty. Change bottle and the problem will disappear.
y Contact the After Sales Service.
y Clean the protective plate above the burner.
y Grill temperature too high: Lower flame.
y Clean the grease drip tray.
y Faulty igniter button, wire or electrode. Check igniter cable connections.
y Check condition of electrode and connection wire.
y Contact the After Sales Service.
y Leaking connection.
y Turn off gas supply immediately.
y Contact the After Sales Service.
y Clogged jet or Venturi tube.
y Contact the After Sales Service.
y Defective tap unit.
y Turn off appliance.
y Contact the After Sales Service.
y Turn off appliance.
y Close gas cylinder.
y Contact the After Sales Service.
25
gB