Preparing For Use; Components Of Your Mesh Base; Attachment Of The Back Motor; Attachment Of The Handset - Auping K2 55 Bedienungsanleitung

3. Preparing for use

3.1 Components of your mesh base

- Auping K2 mesh base.
- Electric motor with remote control.

3.2 Attachment of the back motor

151747 / 151748
1. Attach the back
motor (151747) to
the underside of the
mesh with the screw
and
locking pin, as shown
in the diagrams.
2. Insert the plug of the
back motor into the
control box at con-
nection point 1.
3. Insert the plug of the
remote control into
the control box at
connection point 2.
4. Secure the cords underneath the pull relief
on the control box.
5. Insert the plug of the control box into the
wall socket.
GB4
_006TD_3153 BinnenW.pdf - pag.12
3.3 Attachment of the
• In order to easily
fig. 3
• Place the clamp on the
• Click the handset into

3.4 Fitting the mattress

Put your bed in the horizontal position. Put the
mattress on the mesh base and centre it.
151747
Make sure that the five protruding clip-on pins
of the anchors are pushed widthways into the
mesh (see fig. 5).
'Click' the anchors into the mesh at the posi-
tions indicated (see fig. 6).
Make sure that the anchors are not directly
above a cross bar.
55/59
LET OP !!! Lage resolutie!
handset
attach the handset to
Auping Auronde and
Next or other bed
models.
underside of the side
panel of the surround
(see fig. 4).
the clamp.
fig. 4
fig. 5
fig. 6
November 13, 2007