Ribiland GCS2500 Bedienungs- Und Wartungsanleitung Seite 38

WARNING - Be sure to round off the front edge to reduce the chance of kickback or tie-strap
breakage.
3. Make sure every cutter has the same length and edge angles as illustrated.
6.3.2- Guide Bar
- Reverse the bar occasionally to prevent partial wear.
- The bar rail should always be square.
Check for wear of the bar rail. Apply a ruler to the bar and the out side of a cutter.
If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn.
Such a bar needs to be corrected or replaced.
6.4- Cleaning
Clean plastic parts with a soft clean cloth.
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not put or immerse product in water or any other liquid.
Clean ventilation holes with a soft brush.
6.5- Storage
Product must be stored in a dry location. Always lock up product and keep out of reach of children
6.6- Disposal
When disposing of your machine, remove oil and fuel from the machine, and be sure to follow the
local regulations. Do not dispose of in/with household rubbish.